Next: The need to distinguish Up: MULTIPLE REFLECTION, CURRENT PRACTICE Previous: Deep marine multiples, in

## Pegleg and intrabed multiple reflections

Multiple reflections fall into one of three basic categories--see Figure 6.

multpath
Figure 6
Raypaths are displayed for (a) a water-bottom multiple, (b) a pegleg multiple family, and (c) a short-path multiple.

Water-bottom multiples are those multiples whose raypaths lie entirely within the water layer (Figure 6a). Since the sea floor usually has a higher reflectivity than deeper geological horizons, water-bottom multiples often have strong amplitudes. In deep water these multiples can be very clear and distinct. A textbook-quality example is shown in Figure 1.

Pegleg multiple reflections are variously defined by different authors. Here pegleg multiples (Figure 6b) are defined to be those multiples that undergo one reflection in the sedimentary sequence and other reflections in the near surface.

To facilitate interpretation of seismic data, let us review the timing and amplitude relations of vertical-incidence multiple reflections in layered media. Take the sea-floor two-way travel time to be t1 with reflection coefficient c1. Then the multiple reflection comes at time with reflection strength c1n. Presume also a deeper primary reflection at travel-time depth t2 with reflection coefficient c2. The sea-floor peglegs arrive at times .Note that peglegs come in families. For example, the time could arise from three paths, , ,or .So the order pegleg multiple echo is really a summation of rays, and thus its strength is proportional to .The sea-floor reverberation is c1n, which is not the same function of n as the function that describes reverberation on sediments, .Ignoring the sea-floor reverberation itself you can just think of as a shot waveform.

Every multiple must have a turn-around'' where an upcoming wave becomes a downgoing wave. Almost all readily recognized multiples are surface multiples, that is, they have their turn-arounds at the earth's surface. Figure 7 shows some clear examples.

nearoffset
Figure 7
Near-offset section--offshore Labrador (Flemish Cap). The offset distance is about 9 shotpoints. SF = sea floor, BM1 = first bottom multiple, BM2 = second bottom multiple, P = primary, PM1 = first pegleg multiple, and PM2 = second pegleg multiple. (AMOCO-Canada, Morley)

In land data the turn-around can be at the base of the soil layer, which is almost the same as being at the earth's surface.

A raypath that is representative of yet another class of multiples, called short-path or intrabed multiples, is shown in Figure 6c. Their turn-around is not at or near the earth's surface. These multiples are rarely evident in field data, although Figure 8 shows a clear case in which they are.

intrabed
Figure 8
A rare case of unambiguous intrabed multiple reflections. The data was recorded near Puerto Rico. The inner-bed multiple is between the sea floor and the basement. Thus its travel time is . Do you see it? (Western Geophysical)

When they are identified, it is often because the seismic data is being interpreted using some accompanying well logs. The reason that short-path multiples are so rarely observed compared to peglegs is that the reflection coefficients within the sedimentary sequence are so much lower than on the free surface. The weakness of individual short-path multiples may be compensated for, however, by the very large numbers in which they can occur. Any time a seismic section becomes incomprehensible, we can hypothesize that the data has become overwhelmed by short-path multiples.

Next: The need to distinguish Up: MULTIPLE REFLECTION, CURRENT PRACTICE Previous: Deep marine multiples, in
Stanford Exploration Project
10/31/1997